Peumatic Grouting pump is designed for pressure and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes to have the ability to reinforce the unfastened rock mass. The maximum grain dimension cannot exceed zero.2 mm.
Grouting pump operation and upkeep is straightforward, protected and dependable. This pump is used in mines working under troublesome circumstances as a end result of it is reliable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base frame and stand, strain gauge, pumping cylinder, outlet with fast release coupling and wheels.
How it really works
Pneumatic strain in the air cylinder exerts a high strain on the grout mixture which finally ends up in ejection of grout with a excessive stress and velocity. The valves of the air cylinder in the pump perform routinely to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to complete the pumping cycle.
Pneumatic grout pump could be driven even without Electrical power provide in distant areas by utilizing engine pushed compressor.
Applications
The pump is majorly used in construction and mining industry for injecting material into broad and medium measurement gap in beams, columns ,basement partitions and flooring, carry shaft concrete wall fill-up and so forth. In mining trade it is used to refill cement answer where there is a hole exists between construction and rock and for soil stabilization.
Detachable design tends to simple upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is extensively utilized in tunnels, coal mine, bridges and dams, building basis, and other underground tasks, and inflammable, explosive sites and other bad setting.
It has software in chemical trade additionally to pump out chemical slurries.
The pump is electricity free so, can be utilized at any web site condition whether or not it is rural or urban.
Mining Pneumatic Grouting pump has a larger discharge slurry adjustment vary. Generally the ultimate quantity of the grouting quantity is eight or10 times of the amount in the beginning. And ราคาเพรสเชอร์เกจ grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s stress and flow could be adjusted in accordance with the necessities of grouting,(The move of grouting pump is 0-100L/min, stress of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is principally used for highways, railways, water and electrical energy, development, mining and so on. ground/underground building.
Benefits
Mining Pneumatic Grouting pump has some nice benefits of low energy consumption, small vibration, low noise, small size, high efficiency, dependable performance, stress and circulate management, lengthy life and so on. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can additionally be Light weight and with a wheelie design it might be carried simply. It is designed for straightforward operation and low maintenance. Last but not least its spare elements are easily available.
Share